The information in this article applies to:
QUESTION
How can I build a structure with two shed roofs facing each other?
ANSWER
A clerestory style roof, also known as a mono-pitched, lean-to, or skillion roof, has two shed roofs with ridge or top edges that face one another, and with one top of the ridges higher than the other.
Home Designer will attempt to generate a single, integrated roof plan whenever possible, but by adjusting a structure's height and roof pitch, you can produce different results - like a clerestory.
To create the main structure
- In a New Plan , select Build> Wall> Straight Exterior Wall and create a basic rectangular structure.
In this example, a 20' x 20' structure is used.
- Select Build> Roof> Build Roof and in the Build Roof dialog that displays:
- Specify the desired Pitch (in 12) of the roof.
In this example, a pitch of 4" in 12 is used.
- Specify the Overhangs to your liking.
- Make any additional changes such as the Materials of the roof, then click OK.
-
Using the Select Objects tool, select the top wall and click the Open Object edit tool.
-
On the Roof panel of the Wall Specification dialog that opens, select the Full Gable Wall option and click OK.
Alternatively, you can select the wall and click the Change to Gable Wall(s) edit tool to set this wall as a gable wall without needing to access the dialog box above.
- Repeat this process to set the bottom wall as a Full Gable Wall so that a gable roof with a ridge in the center of the building is created.
- Navigate to Build> Floor> Build New Floor from the menu, select the Derive new 2nd floor plan from the 1st floor plan option in the New Floor dialog that displays, then click OK.
- In the 2nd Floor Defaults dialog, change the Rough Ceiling value to be the height of the clerestory you want to create, then click OK.
In this example, a value of 48" is used.
- With the second floor present in the floor plan, select the left or right hip wall, and move it into the center of the structure.
- After the wall has been moved, select it, and click the Open Object edit tool.
- In the Wall Specification dialog that displays, click on the Roof panel, select the High Shed/Gable Wall option, then click OK.
- Using the Select Objects tool, click inside of the second floor room to select it and click on the Open Object edit tool.
- In the Room Specification dialog:
- On the General panel, change the Room Type to Open Below.
- On the Structure panel, uncheck Flat Ceiling Over This Room.
- This would also be a good time to change the Rough Ceiling value again if needed.
- Click OK to confirm the changes and close the dialog.
- Lastly, take a Camera view to see the results.